Page 2 of 2

Re: please help me

PostPosted: Wed Apr 06, 2011 1:25 pm
by cx_star
Dopi wrote:Where exactly did you load the bootloader in RAM? Which adress?

yes, the address is from 50008000.
i had read it and print it by uart, it's right ,see the codes above.

Re: Re: please help me

PostPosted: Wed Apr 06, 2011 10:52 pm
by Dopi
cx_star wrote:
Dopi wrote:Where exactly did you load the bootloader in RAM? Which adress?

yes, the address is from 50008000.
i had read it and print it by uart, it's right ,see the codes above.

I will check if this is what i think should be it. As far as I remember the memory location was not all straight forward.

Cheers,
Dopi

Re: please help me

PostPosted: Thu Apr 07, 2011 3:42 am
by cx_star
what i do is just under steps:
1, the cpu will read a little codes from tf,when power on.
2, by the little codes, it read jetqi to ram from tf, then call start_qi()

Re: Re: please help me

PostPosted: Sat Apr 16, 2011 1:13 am
by cx_star
Dopi wrote:I will check if this is what i think should be it. As far as I remember the memory location was not all straight forward.

Cheers,
Dopi


so is it right?