Page 1 of 1

does samsung jet support ipv6?

PostPosted: Mon Jul 25, 2011 1:24 pm
by xxbluedevilsxx
i cant find the answer on google :lol:

Re: does samsung jet support ipv6?

PostPosted: Mon Jul 25, 2011 2:08 pm
by Carlos_Manuel
Did you checked in wikipedia?

I'ts maybe can work but it need zImage with ipv6 text.. (maybe)

Re: does samsung jet support ipv6?

PostPosted: Mon Jul 25, 2011 8:48 pm
by MadRocker
You will need to check the jet_android.config or the 14Jul zImage .config if not there then shout and I can re-build a ipv6 ready 14Jul kernel.
I will check if the kernel is ready for ipv6 or maybe it needs some tweaking.

Re: does samsung jet support ipv6?

PostPosted: Sat Jul 30, 2011 4:43 am
by MadRocker
Blue try this one, it has ipv6 and the dhd.ko is ipv6 ready as well.

As for the quality or if it will work or if the ipv6 is stable in the kernel = no clue.
This is the 14Jul2011 zImage + ipv6 added, "usb-gadget serial acm" and 100mw for usb gadgets so battery life over a long time might be influenced.

Also check for the cpu scaling / governing command in the init.rc as this should compensate for the cpu in performance vs conservative speeds.

What or how this will influence your router ipv6 or 6to4 and if you need a ipv6 tunnel broker like gogoclient or hurricane ipv6 tunnel = no clue. Also your router might need to be in ipv6 bridge or what is the word rebroadcast type setting.

if you are using dd-wrt or tomato then there is a guide to get opendns ipv6 setup in 2 stages with ddns as well.

Hope this helps. PS> I did not test this kernel yet.

Re: does samsung jet support ipv6?

PostPosted: Sat Jul 30, 2011 1:39 pm
by Carlos_Manuel
Hi MadRocker

zImage: works fine with Eclair Jet 2.0.1

Your ipv6 zImage + modules multidpd.ko and dhd.ko: WORKS FINE

Battery: shows ? <---- mark

P.S. with this zImage the Quadrant in 2.0.1 is 265 point so this zImage is really good! ;)

EDIT: maybe the screen flickering more now in 2.0.1 .. ?
And sensors works fine!

Re: does samsung jet support ipv6?

PostPosted: Sat Jul 30, 2011 5:33 pm
by MadRocker
Yup the battery is set for the s3c*battery.ko but power management in the kernel is still holding it back form completing the battery status process.

The flicker should be the same as that depends on the lib* s3c and surface files + good fimg* . ../hw files could make flicker problems as well.

Re: does samsung jet support ipv6?

PostPosted: Sat Jul 30, 2011 6:38 pm
by Carlos_Manuel
MadRocker wrote:Yup the battery is set for the s3c*battery.ko but power management in the kernel is still holding it back form completing the battery status process.

The flicker should be the same as that depends on the lib* s3c and surface files + good fimg* . ../hw files could make flicker problems as well.


OK :)

Edit: I have JetDroid-JetPlatform_binary-c397cae fimg files in 2.0.1 and libs3crender.so and other but the screen flickering not stop.. :/

I cant fix it because it maybe needs 2.0.1 egl files + hw files..? or 1.6 .. ?